I'd love to keep these speakers and re-use them in some new setup (with a new sub), but no idea where to start. The placement/flexibility of the volume control is also important, being on the right speaker isn't too bad.ĭistance between shelf and desk edge is 10cm, which would give a height to the bottom of the monitors of roughly 19cm, though possibly limit any direction of the satelites.ĭistance between the shelf and bottom of the monitors is roughly 11cm. This fix can be done by most here in 20 minutes and is a permanent fix adding external speakers will not fix this problem. you also need headroom like if you NEED 25w of power you should use a 50wpc amp so that your not clipping on bass peaks and musical peaks. As posted above it is a grounding issue with the front panel of the SDS200 and the STATICDISCHARGE fix is going to be your only real fix. I control EQ on the PC, so was tempted for the monitor approach (I also do occasional recording/streaming, but not enough to overly worry about). Subwoofer Control Panel BASS LEVEL CAMBRIDGE SOUNDWORKS NEWTON, MASSACHUSETTS AUDIO INPUT SPEAKERS 12V DC IN POWER ON/OFF. this has alot to do with you speakers sensitivity an the amount of volume and space your hoping to gain/fill. I also have a Scarlett Solo under the desk, so could use that for output, if it makes any difference to anything (maybe using monitors?), but I use that for headphones (switch my audio out on the pc to the Scarlett when I want to headphones, so I don't need to plug anything in. The satellite speakers are also connected with arbitrary speaker wires - another must. I currently have the sub sat behind me with an extension cable for the volume control (which goes into the sub), and so need to be able to extend cables between speakers and the sub with ease, static cables won't do, which rules out most Logitech stuff. I've been looking for alternative speakers which always seem to fail one requirement, usually the cable to the sub. The issue you posted is a post Windows 7 installation issue and would be better suited in the TechNet community. Like many, this setup has served me incredibly well for probably 25 years, the volume knob can't easily be replaced, since the original pots are impossible to find, but I'm nearly tempted to fashion a new enclosure for a new volume control. I have a failing setup, consisting of a 2.1 Cambridge Soundworks (common issue with swelling volume randomly due to failing pot in volume control).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |